TUFF TOE ROLLER SKATE PROTECTION - SINGLE USE

Tuff Toe Skate Protection is an abrasion, chemical, and water resistant polyurethane adhesive specially designed to provide long-term protection for your skates. According to the manufacturer, Tuff Toe will extend the life of your shoes or skates by up to 3X.

Tuff Toe Skate Protection will save your skates from wear caused by repetitive contact with concrete, asphalt, wood, ramps and bowls. Tuff Toe is applied as a thick 2-part epoxy/polyurethane and cures to form a durable yet flexible protective layer with a permanent bond. One package contains enough material to cover all of your hard wear areas on two shoes. 

IN OUR EXPERIENCE EACH PACK HAS ENOUGH MATERIAL FOR TWO PAIRS OF SKATES. 

Application Process

STEP 1: MARK AREA – Use tape to make an outline of the area to be protected.

STEP 2: PREP – Clean and sand the area well

STEP 3: FOLLOW INSTRUCTIONS ON Burst BAG – Tuff Toe is a two-part application that needs to mix simultaneously at the time of application. Push one side of Tuff Toe into the other side by breaking the burst seal. Floss the bag back and forth over a table edge for 60 seconds.

STEP 4: APPLY TO TOE – Cut off the corner of the bag and push the material where you want it on the shoe. Immediately remove the tape. Pull carefully so that you don’t mess up your application.

STEP 5: ROTATE – Rotate the shoe for 1-2 mins with the toe tip pointed down to allow the material to spread evenly and avoid runs.

STEP 6: CURE FOR 24 HOURS – Material will be 80% cured after 90 minutes, but please allow 24 hours for a full cure or add heat to speed the cure. Leave in a hot car for a few hours.

Made in the USA.